SGMGH-05ACA6C High Speed Feed Series Large Capacity Controller

Large capacity sgmvv servo motor.

Rated output: 22KW.

Voltage: three phase ac200v.

Serial encoder: 20 bit incremental type.

Rated speed: 800r/min.

Main mechanical structure: flange mounted, straight shaft end (with keyway and screw hole) servo motor.

Option: with holding brake (dc90v).

The use of small, low inertia servo motors can also give full play to the strong performance of machinery.

The new sgmvv model is equipped with products with rated output of 22~55kw, rated passenger speed of 800r/min and 1500r/min.

The phase starts running immediately after the motor is installed.

Even without servo adjustment, as long as the moment of inertia is within the allowable range,

Even if the load changes, it can be driven stably without vibration. Σ- V series servo motor sgmav type.

Rated output: 0.05kw (50W).

Power supply voltage: ac200v servo motor.

Serial encoder: 20 bit incremental type (standard).

Design sequence: standard.

Shaft end: straight shaft, without keyway (standard).

Optional: without optional.

High power change rate.

Small capacity.

Low inertia

Instantaneous large torque (rated ratio 300%).

Equipped with high-resolution serial encoder (20 bits).

High speed up to 6000r / min.

Complete varieties (50W ~ 1.0kw, with holding brake).

Example of use:

Semiconductor manufacturing equipment,

Mounter,

PCB punching machine,

robot,

Handling machinery,

Food processing machinery.

Rating and specification:

Rated time: continuous.

Vibration level: V15.

Edge resistance: DC500v, above 10m Ω.

Ambient temperature: 0 ~ 40 ° C.

Excitation mode: permanent magnet type.

Installation method: flange type.

Heat resistance grade: B.

Edge withstand voltage: ac1500v1

Connection mode: directly connect the servo motor.

Rotation direction: CCW rotation when viewed from the load side under the forward rotation command. Servo motor sgmgh type.

Rated speed: 1000r/min.

Power: 0.9Kw.

Power supply voltage: three-phase ac200v.

Serial encoder: 17 bit relative value.

Design sequence: for machine tool.

Shaft end: straight shaft with key and screw hole.

Options: with oil seal, DC24V braking.

High speed feed series: sgmgh-05aca6c is used for occasions that need high-speed operation even when there is no load.

The power supply of the main circuit and the control circuit are completely separated,

In case of alarm, only the power supply of the main circuit is turned off, which is easy to maintain sgmgh-05aca6c.

Built in parameter setter.

Parameters can be directly input by the servo driver body.

Save wiring.

Serial encoder is adopted, and the number of encoder wiring is reduced by 1/2 compared with the original product.

Multi in one control: torque, position and speed control can be used instead of parameter switching.